最新刊期

    期 0 , 2020
    • GUO Wen jing,WANG Zheng,ZENG Zhen
      Issue 1, Pages: 5-7(2000) DOI: 10.19455/j.mcgy.2000.01.002
      摘要:Non woven liner was pretreated with different chemicals and the influence to the wood fiber synthetic fiber composite was studied. The result indicated that pretreatment could eliminated the adverse effect of non woven liner to the composite. The best dosage of chemicals for pretreating is 100% of the weight of the non woven liner.  
      关键词:Non woven liner;pretreatment;Internal bond strength   
      3
      |
      54
      |
      4
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614464 false
      发布时间:2021-03-12
    • CHEN Yu he 1,LU Ren shu 2,LI Zong ran 1
      Issue 1, Pages: 8-11(2000) DOI: 10.19455/j.mcgy.2000.01.003
      摘要:The study found that the major factors affecting dye up take were the constitution of the liquor and the parameters of dyeing process. The 0.5 mm sliced Paulownia elongata veneer was dyed in an experiment by the acid bright red. It was shown that NaCl produced an obvious effect. The percent of dye up take increased with the increase of NaCl concentration and then decreased after highest point at 1%. The dye up take increased with increase of liquor temperature. The percent of dye exhaustion gradually ascended with the time going in experiment until to reach the adsorption equivalent state. The result was satisfied for the 0.5 mm sliced Paulownia elongata veneer at 90 ℃ for 3 h. The dye up take was different with the change of dye concentration, and the best concentration was 1%. The adsorption was different with the change of the bath ratio of the liquor to wood. The suitable bath ratio was 15. Acetic acid took an active part in promoting the percentage of exhaustion with the best concentration of 1.5%.  
      关键词:Paulownia veneer;dyeing;Dye up take   
      3
      |
      128
      |
      39
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614552 false
      发布时间:2021-03-12
    • ZHOU Xiao yan,HUA Yu kun,HU Qing long
      Issue 1, Pages: 12-15(2000) DOI: 10.19455/j.mcgy.2000.01.004
      摘要:The house climate (including temperature and relative humidity of inside and outside of wall surface, the distribution in vertical space of temperature and relative humidity inside, etc.) of oriented structural board (OSB) building and brick building in winter and summer were tested by automatic recorder. It was indicated that the house climate of OSB building (the structure of wall is OSB+glass wool+OSB) was better than that of the brick and concrete building for human’s health. The indoor temperature of OSB building is steady.  
      关键词:Oriented structural board(OSB);Indoor heat environment;House climate   
      3
      |
      62
      |
      4
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614522 false
      发布时间:2021-03-12
    • PIAO Cheng han,TENG Tong lian
      Issue 1, Pages: 16-18(2000) DOI: 10.19455/j.mcgy.2000.01.005
      摘要:Acacia mangium belongs to the fast growing plantation species in the tropical area, the diameter of the tree trunk is small, and the proportion of the juvenile wood is large. The wood is easy to dry, but the collapse and inner crack occurs easily, so a low temperature schedule is recommended, and more conditioning should be done, so that drying stress and plastic distortion can be reduced, and the collapse and inner crack can be avoided. The integrated method of air drying and kiln drying is recommended to reduce drying time, energy consumption, and drying cost.  
      关键词:Acacia mangium;Drying characteristic;Air drying;Kiln drying   
      7
      |
      85
      |
      15
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614501 false
      发布时间:2021-03-12
    • YIN Ming fang
      Issue 1, Pages: 19-20(2000) DOI: 10.19455/j.mcgy.2000.01.006
      摘要:This article introduces the short term objective in the field of development and research of wood processing technology, prepared by Japanese government according to the change of wood market .It would be of great value for our country to use as a reference in making the research target of wood science and technology.  
      关键词:Wood processing;new technology;Development   
      9
      |
      30
      |
      2
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614474 false
      发布时间:2021-03-12
    • WANG Gang,WANG Wei,LI Rui fen,LI Dong sheng
      Issue 1, Pages: 24-26(2000) DOI: 10.19455/j.mcgy.2000.01.008
      摘要:Condition monitoring and fault diagnosis of equipment is very important in industry sector, but the wood based panel industry is less developed in this field. This paper discusses the present situation and necessity of the development of condition monitoring and fault diagnosis of equipment in the wood based panel industry, and put forward some countermeasures in view of existing situation.  
      关键词:Wood based panel industry;Condition monitoring of equipment;Fault diagnosis   
      4
      |
      47
      |
      1
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614481 false
      发布时间:2021-03-12
    • HUA Jun,PU An bin,LU Ren shu
      Issue 1, Pages: 27-29(2000) DOI: 10.19455/j.mcgy.2000.01.009
      摘要:The paper analyses the producing cost of diphenylmethane diisocyanate (MDI) wheat straw particleboard from the scale of production and direction of investment etc. It is helpful to the extension and commercial production of this new product.  
      关键词:Diphenylmethane diisocyanate(MDI);Wheat straw particleboard;Producing cost   
      3
      |
      135
      |
      15
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614543 false
      发布时间:2021-03-12
    • LU Xue liang,CHENG Qing zheng,MA Wei
      Issue 1, Pages: 30-31(2000) DOI: 10.19455/j.mcgy.2000.01.010
      摘要:Through adjustment and test run of TIR E four beam of light infrared rays moisture meter on medium density fiberboard (MDF) production line, the influence factors of its precision were discussed. Some useful advices were also given.  
      关键词:Wood fibre;Infrared rays moisture meter;moisture content   
      4
      |
      77
      |
      1
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614492 false
      发布时间:2021-03-12
    • ZHOU Zhao1,CAO Jian-chun1,TANG Pei-zhao1,RUIBing-quan2,MENG Yu-lin2
      Issue 1, Pages: 32-34(2000) DOI: 10.19455/j.mcgy.2000.01.011
      摘要:In this paper, the relationship betw een technological param eters (such as adhesive consum ption, pressing tem perature and pressing tim e) ofparticleboard overlaid w ith alum inum foil and the properties ofcom posite panelw ere discussed. The resultsshow ed thatthe m echanicalprop- erties especially the MOR of the com posite panelw ere increased obviously glued w ith epoxy resins w ith adhesive consum ption 490~630 g/m 2, pressing tem perature 80 ℃, pressure 0.2 MPa and pressing tim e 5 m in. This kind ofpanelare good to be used as packing,decorating and fitting m ate- rial.  
      关键词:particleboard;Overlaid;Alum inium foil   
      3
      |
      67
      |
      23
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614531 false
      发布时间:2021-03-12
    • JIN Zhao-yi1,XU Mei-qi2
      Issue 1, Pages: 35-37(2000) DOI: 10.19455/j.mcgy.2000.01.012
      摘要:In this paper the basic principle, tem perature and w ood species adjustm ent theory, design principle of conductance w ood m oisture m eter is described. Determ ination error analysis show ed there w as no obvious difference betw een the m eters m ade in China and abroad. This paper also analyses the developm ent trend of high m oisture content determ ination, the m easure to im prove reliability and to develop intelligent on line determ ination technology.  
      关键词:wood;Moisture m eter;Conductance;Determ ination   
      5
      |
      327
      |
      22
      <HTML>
      <L-PDF>
      <引用本文> <批量引用> 6614572 false
      发布时间:2021-03-12
    0