制造工艺参数对聚乙烯膜增强柚木薄木性能的影响

彭晓瑞; 张占宽; 杨旭

doi:10.19455/j.mcgy.20180302

研究与开发 | 浏览量 : 0 下载量: 31 CSCD: 0

PDF
导出
分享
收藏
专辑

制造工艺参数对聚乙烯膜增强柚木薄木性能的影响
Effects of Manufacturing Parameters on Performance of Teak Decorative Veneers Enhanced with Polyethylene Films
1. 中国林科院木材工业研究所
2. 国家林业局木材科学与技术重点实验室3. 北京霍尔茨门业股份有限公司
2018年32卷第3期页码：5-8
DOI： 10.19455/j.mcgy.20180302

扫描看全文

[1]彭晓瑞,张占宽,杨旭.制造工艺参数对聚乙烯膜增强柚木薄木性能的影响[J].木材工业,2018,32(03):5-8.

PENG Xiao-rui, ZHANG Zhan-kuan, YANG Xu. Effects of Manufacturing Parameters on Performance of Teak Decorative Veneers Enhanced with Polyethylene Films[J]. China Wood Industry, 2018,32(3):5-8.
[1]彭晓瑞,张占宽,杨旭.制造工艺参数对聚乙烯膜增强柚木薄木性能的影响[J].木材工业,2018,32(03):5-8. DOI： 10.19455/j.mcgy.20180302.

PENG Xiao-rui, ZHANG Zhan-kuan, YANG Xu. Effects of Manufacturing Parameters on Performance of Teak Decorative Veneers Enhanced with Polyethylene Films[J]. China Wood Industry, 2018,32(3):5-8. DOI： 10.19455/j.mcgy.20180302.

摘要

以聚乙烯膜和柚木薄木为试材,考察等离子体处理进给速度、热压温度、压力及时间等工艺参数对聚乙烯膜增强柚木薄木性能的影响。结果表明:热压温度对柚木薄木剥离强度和横向抗拉强度的影响极显著,等离子体处理进给速度的影响显著。在等离子体进给速度3 m/min,热压压力0.8 MPa、温度135℃、时间150 s等较优条件下,柚木薄木的剥离强度达0.51 k N/m,抗拉强度达4.13 MPa,柔韧性检测钢棒直径可小至4 mm,浸渍剥离达到I类要求。

Abstract

Flexible decorative veneers were made by low temperature plasma treatment to improve the interface between teak veneers and low density polyethylene（LDPE） films. The veneers and films were then joined by hot-pressing.Results showed that peel strength and transverse tensile strength were most significantly impacted by hot pressing temperature followed by plasma processing speed.Optimal technology for making the veneers was 0.8 MPa of hot-pressing pressure,135℃of temperature,150 s of pressure time and 3 m/min of plasma processing speed.0.51 k N/m of peel strength,4.13 MPa of transverse tensile strength and good flexibility of the veneers were achieved under the above manufacturing parameters.