轻质豆秸刨花板工艺的研究

邢成; 殷苏州; 邓玉和

doi:10.19455/j.mcgy.1999.06.002

浏览量 : 0 下载量: 88 CSCD: 9

PDF
导出
分享
收藏
专辑

轻质豆秸刨花板工艺的研究
Manufacture Technology of Low Density Particleboard from Soybean Stalk
1. 南京林业大学木材工业学院!工程师
2. ,南京,210037
3. 南京林业大学木材工业学院,南京,210037
1999年第6期页码：7-9
DOI： 10.19455/j.mcgy.1999.06.002

扫描看全文

[1]邢成,殷苏州,邓玉和.轻质豆秸刨花板工艺的研究[J].木材工业,1999(06):7-9.

Xing Cheng Yin Suzhou Deng Yuhe. Manufacture Technology of Low Density Particleboard from Soybean Stalk[J]. China Wood Industry, 1999,(6):7-9.
[1]邢成,殷苏州,邓玉和.轻质豆秸刨花板工艺的研究[J].木材工业,1999(06):7-9. DOI： 10.19455/j.mcgy.1999.06.002.

Xing Cheng Yin Suzhou Deng Yuhe. Manufacture Technology of Low Density Particleboard from Soybean Stalk[J]. China Wood Industry, 1999,(6):7-9. DOI： 10.19455/j.mcgy.1999.06.002.

摘要

从UF胶制造轻质豆秸刨花板的初步研究,分析了板的密度、施胶量、热压时间等工艺因子对板性能的影响。试验结果表明,利用豆秸制造轻质刨花板是完全可行的,其产品主要物理力学性能为:密度0.483 g/cm 3、吸水厚度膨胀率11.2 % 、内结合强度0.303 MPa、静曲强度8.98 MPa,均达到日本JISA 5908 的技术指标。

Abstract

Low density particleboard was produced from soybean stalk using urea formaldehyde (UF) resin as adhesive under laboratory conditions. The influences of three processing variables, i.e . density, resin consumption and pressing time on physical and mechanical properties of the board were analyzed. Results showed that soybean stalk was a suitable raw material for low density particleboard. The main physical and mechanical properties of the board can reach the requirements of JIS A 5908. Overlaying with melamine impregnated paper or veneer can greatly improve MOR of the board.

关键词

豆秸轻质刨花板物理力学性能

Keywords

Soybean stalkLow density particleboardPhysical mechanical properties

references

文章被引用时，请邮件提醒。

提交

豆秸刨花板工艺的初步研究