Measurement and Analysis of Normal Pressure on a Brush Sanding Machine

WANG Bao-gang1; ZHANG Zhan-kuan1; PENG Xiao-rui1; LI Wei-guang1

doi:10.19455/j.mcgy.2013.01.016

Piactical Techniques | Views : 0 下载量: 41 CSCD: 4

PDF
Export
Share
Collection
Album

Measurement and Analysis of Normal Pressure on a Brush Sanding Machine
1. Key Laboratory of Wood Science and Technology of State Forestry Administration
2. Research Institute of Wood Industry,Chinese Academy of Forestry
Vol. 27, Issue 1, Pages: 50-53(2013)
DOI： 10.19455/j.mcgy.2013.01.016

扫描看全文

[1]王宝刚,张占宽,彭晓瑞,李伟光.条状刷式砂光机法向压力的测量与分析[J].木材工业,2013,27(01):50-53.

WANG Bao-gang1, ZHANG Zhan-kuan1, PENG Xiao-rui1, et al. Measurement and Analysis of Normal Pressure on a Brush Sanding Machine. [J]. China Wood Industry 27(1):50-53(2013)
[1]王宝刚,张占宽,彭晓瑞,李伟光.条状刷式砂光机法向压力的测量与分析[J].木材工业,2013,27(01):50-53. DOI： 10.19455/j.mcgy.2013.01.016.

WANG Bao-gang1, ZHANG Zhan-kuan1, PENG Xiao-rui1, et al. Measurement and Analysis of Normal Pressure on a Brush Sanding Machine. [J]. China Wood Industry 27(1):50-53(2013) DOI： 10.19455/j.mcgy.2013.01.016.

摘要

为了研究条状刷式砂光机用于木制品异形部件砂光时,法向压力的变化规律,在不同理论接触长度、砂光条长度、砂光条偏转角度等条件下,对水曲柳试件进行砂光处理并测量法向压力。结果表明,砂光条施加到试件上的法向压力,随着理论接触长度、偏转角度的增大而增大,随着砂光条长度的增大而减小。用于异形面砂光时,适当增加砂光条的长度,可减小凹凸平面间法向压力的差值,增强条状刷式砂光机的形状适应性。

Abstract

Normal pressures on a brush sander with different theoretical contact lengths,sanding-strip lengths,and deflection angle were measured and analyzed.The results showed that normal pressure increased with increased theoretical contact length and deflection angle.Increasing the sanding strips length could decrease the D-value pressure for different planes and enhance the brush sanding adaptability.

关键词

条状刷式砂光机法向压力异形砂光

Keywords

brush sanding machinenormal pressurespecial-shaped sanding

references

Alert me when the article has been cited

提交

暂无数据