Study on the Prestressed Control for Glulam Continuous Beams Using SAP2000

Nan GUO; Qi-hui ZHANG; Yi-dan WU; Xin-yi GUO; Wei ZHANG; Jia-ning WEI

doi:10.12326/j.2096-9694.2020037

RESEARCH PAPERS | Views : 0 下载量: 7 CSCD: 0

PDF
Export
Share
Collection
Album

Study on the Prestressed Control for Glulam Continuous Beams Using SAP2000
1.College of Civil Engineering，Northeast Forestry University， Harbin 150040，Heilongjiang，China
Vol. 35, Issue 2, Pages: 42-48(2021)
DOI： 10.12326/j.2096-9694.2020037

扫描看全文

郭楠,张启珲,吴亦丹等.基于SAP2000分析的预应力胶合木连续梁调控效果[J].木材科学与技术,2021,35(02):42-48.

GUO Nan,ZHANG Qi-hui,WU Yi-dan,et al.Study on the Prestressed Control for Glulam Continuous Beams Using SAP2000[J].Chinese Journal of Wood Science and Technology,2021,35(02):42-48.
郭楠,张启珲,吴亦丹等.基于SAP2000分析的预应力胶合木连续梁调控效果[J].木材科学与技术,2021,35(02):42-48. DOI： 10.12326/j.2096-9694.2020037.

GUO Nan,ZHANG Qi-hui,WU Yi-dan,et al.Study on the Prestressed Control for Glulam Continuous Beams Using SAP2000[J].Chinese Journal of Wood Science and Technology,2021,35(02):42-48. DOI： 10.12326/j.2096-9694.2020037.

摘要

为了充分利用胶合木的抗压强度，常在梁中施加预应力，但受反拱幅度等影响，施加预应力需控制在合理范围内。通过SAP2000有限元程序建立分析模型，与试验结果对比验证其可行性后，对8种调控幅度的梁进行分析，得到荷载-挠度曲线、梁截面应力云图、极限承载力及合理调控范围。结果表明，调控幅度为极限荷载的18%~48%时，极限荷载增大3.65%~58.1%，胶合木连续梁的承载力基本呈线性增加；调控幅度为54%时，梁因破坏形态发生改变承载力开始下降。预应力胶合木连续梁的合理调控范围为极限荷载的24%~42%。

Abstract

In order to take full advantage of the compressive strength of glulam, prestress is often applied on the beam. However, due to the influence of the arch amplitude and other reasons, the range of prestress can't be overly large, which will limit the full strength of the glulam and prestressed steel. For this reason, this study investigated the method of prestressed control of the glulam continuous beam. The finite element analysis model was generated using the SAP2000 program. The computer model was compared with the experimental results to verify the feasibility of the method. The load-deflection relation curve, the stress cloud diagram of beam section, the ultimate bearing capacity, and the reasonable control range of 8 beams with different control amplitudes were analyzed. The results show that when the control range is at 18%~48% of the ultimate load, the ultimate load increases by 3.65%~58.1%. At the same time, the bearing capacity of the glulam continuous beam increases linearly. When the range of control was over 54%, due to the change of failure mode, the bearing capacity of the beams began to decline. Finally, the reasonable control range of the prestressed glulam continuous beam is approximately 24%~42% of the ultimate load.

关键词

胶合木连续梁预应力调控有限元分析极限荷载

Keywords

glulam continuous beamprestressed controlfinite element analysisultimate load

references

Guo Nan, Wang Yan-Jun, Zuo Hong-Liang. Study of short-term flexural behavior for glue bamboo and lumber beams under different perstressed states[J].The Civil Engineering Journal, 2017(26): 128-142.

张济梅,潘景龙,董宏波.张弦木梁变形特性的试验研究[J].低温建筑技术, 2006, 28(2): 49-51.

ZHANG J M, PAN J L, DONG H B. Experimental research on deformation characteristic of timber beam string structure[J].Low Temperature Architecture Technology, 2006, 28(2): 49-51.

张济梅, 潘景龙. ANSYS分析张弦木梁的变形性能[J].低温建筑技术, 2008, 30(4): 70-71.

ZHANG J M, PAN J L. Research on deformation characteristic of timber beam string structure using ansys fem[J].Low Temperature Architecture Technology, 2008, 30(4): 70-71.

张济梅, 潘景龙, 董宏波. 张弦木梁预应力损失初步探讨[J].低温建筑技术, 2007, 29(1): 73-75.

ZHANG J M, PAN J L, DONG H B. Discussion on prestressing loss of timber beam string structure[J].Low Temperature Architecture Technology, 2007, 29(1):73-75.

De Luca V, Marano C. Prestressed glulam timbers reinforced with steel bars[J].Construction and Building Materials, 2012(30): 206-217.

宋彧, 林厚秦, 韩建平, 等. 预应力钢筋—木结构受力性能的试验研究[J].结构工程师, 2003(1): 54-60.

王锋, 王增春, 何艳丽, 等. 预应力纤维材料加固木梁研究[J].空间结构, 2005, 11(2): 34-38.

WANG F, WANG Z C, HE Y L, et al. Research of prestressed FRP in the reinforcement of timber beams[J].Spatial Structures, 2005, 11(2): 34-38.

王增春，南建林，王锋. CFRP增强木梁的预应力施工方法[J].施工技术, 2006, 35(10):73-75.

WANG Z C, NAN J L, WANG F. Construction method of timber beam prestressed by CFRP[J].Construction Technology, 2006, 35(10): 73-75.

王增春，南建林，王锋. CFRP增强预弯木梁抗弯承载力计算方法[J].建筑科学, 2007, 23(9): 7-11.

WANG Z C, NAN J L, WANG F. Calculation method of flexural bearing capacity of preflexed timber beams reinforced by CFRP[J].Building Science, 2007, 23(9): 7-11.

Anshari B, Guan Z W, Kitamori A, et al. Structural behaviour of glued laminated timber beams pre-stressed by compressed wood[J].Construction and Building Materials, 2012(29): 24-32.

GUAN ZW, Rodd P D, Pope DJ. Study of glulam beams pre-stressed with pultruded GRP[J].Computers & Structures, 2005, 83(28/30): 2476-2487.

McConnell E, McPolin D, Taylor S. Post-tensioning of glulam timber with steel tendons[J].Construction and Building Materials, 2014(73): 426-433.

GUO Nan, HE Tie, CHEN Hui-Hui. The research of the influence of constitutive relation on glued-timber beam bending performance analysis results[J].International Journal of Earth Sciences and Engineering, 2015, 8(2): 665-670.

David W Green, Jerrold E Winandy, David E Kretschmann. Wood handbook Chapter 4: mechanical properties of wood[M].Forest Products Laboratory, Wisconsin 1999.

Alert me when the article has been cited

提交

Optimal Design of Log Conveyor Dial Device for Veneer Rotary Peeling Production Line

Wood-roof Structure Reinforcement and Finite Element Analysis